MICRO-AIR Artic Air 24 Guía de instalación Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 63
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
To Install your cooling water zinc holder:
Your Micro HPS system is supplied with a zinc to protect the cupronickel
seawater condenser from electrolysis in case there are stray electrical
currents present in the water. The zinc holder consists of a “y” shaped tube
with a zinc in one arm of the Y and a ground wire that attaches to a screw
on the condensing unit mounting base.
The Y shaped zinc holder needs to be installed in the seawater intake line for the Micro HPS
condensing unit, using the supplied heat shrink hose clamps and a short piece of water hose.
The part of the Y containing the zinc must be horizontal or below, so that it will not dry out when
the pump is not running. No!
(180º horizontal)
O.K.
The head of the zinc can be facing towards or away from the Micro HPS, but it will probably be
easier to service in the future if it facing away. Leave room for
future zinc replacement.
When you are ready to install the zinc holder, the heat shrink
hose clamp should be removed from the cardboard ring by
crushing the ring with your fingers.
The clamp can then be removed from the ring and slipped over
the Micro HPS intake tube.
The short piece of hose should extend over the intake tube far enough that the clamp has copper
beneath it and not bare hose.
Shrink the clamp in place with a heat source such
as a heat gun or the flame from a lighter or
propane torch. Be sure to use enough heat to
evenly shrink the clamp, especially on the top.
The second supplied heat shrink clamp should be used to hold the Y zinc holder to the other end
of the short piece of water hose. Connect the end of your intake water hose to the zinc holder
with a standard stainless hose clamp
or another heat shrink clamp (not
supplied).
Once the zinc holder is in place, the
ring terminal on the ground wire
should be attached to the neighboring
screw per the picture, using the 1/8"
Allen key or hex wrench.
Spare zincs with nut are available
under GB part number MHZINC. The
pencil zinc is 3/8” x 2” with a 1/4”
thread.
Page 15
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 62 63

Comentarios a estos manuales

Sin comentarios